6G Welding Test Tips for Root Pass Using Tig

6G Welding Test


Click here to subscribe to my Video of the Week!




If a 6G welding test is standing between you and a good paycheck, pay attention… This video is for you.

A common pipe welding test is a 6 inch tig root and hot pass with a stick 7018 fill and cap.

If you can get the root in right, it gets easier after that.

This video shows tips for laying the wire in the gap and then scooting forward and backward to achieve some good penetration.

Have you got any tips for a tig root pass?


( As always, feel free to visit us at our sister site, WeldingTipsAndTricks.com. )


Click here to subscribe to my Video of the Week!


8 Comments

  1. michael connor

    March 21, 2014 at 5:27 AM

    The part where you are counting was a big help as Im a counter for hand movements. Your shows are a good source of information you take pride in your work as well big part of the weld

  2. Welded 10 coupons out before getting mad and looking at your video nailed the first try with your help can’t thank you enough

  3. Thanks a lot man your video helped me so much.your technique worked great for me.

  4. Nie job man I am aaa Multie welder But no one job . I want job

  5. Jody, great tips on 6g root pass . would love to see copper plate (sheet) 16 to 24 gauge. my wife wants to learn, help

  6. Nice could you show us a 2 Inch 309 SS stick test

  7. Nice video Jody. I would like to see a 6010 root pass

  8. Nice video Jody. I would like to see a 6010 root pass from you

Leave a Reply

Your email address will not be published.

*

© 2024 Weldmonger™

Back to Top ↑