Tag: how to tig weld aluminum (page 1 of 7)

AC Frequency Settings: TIG Welding Aluminum






TIG Welding Aluminum

Video Transcript:

AC Frequency Settings: TIG Welding Aluminum

I’m TIG welding aluminum today, and I’m comparing AC frequency. I’m gonna compare 50 hertz to 250 hertz. I’ve got some aluminum tubing, some eight-inch aluminum tubing, O-70 wall. It’s a bit less, a little bit less than two millimeters thick. I’m gonna set it up on a positioner and I’m gonna compare penetration, same amperage, 50 hertz, 250 hertz. Let’s do it. read more

Aluminum Tote Tray Project


Tote Tray Project

Below are some products that I don’t carry, but I use them in my videos and can vouch for their quality.

WELDING MACHINES

Lincoln Viking 3350 w/4C

http://amzn.to/2rRFlUn

Lincoln Square Wave TIG 200

http://amzn.to/2rSkekZ

Lincoln Power MIG 210 MP

http://amzn.to/2s2bRnA

AHP Alpha TIG 200X

http://amzn.to/2s1XAr3 read more

Welding Aluminum: MIG Spool Gun vs TIG




Welding Aluminum

Video Transcript

Welding Aluminum: MIG Spool Gun vs TIG

Hey. Jody here, with WeldingTipsandTricks.com. Last week’s video was part one of the aluminum awning build. We put together a lot of the structure in JD’s shop, all TIG welding with a 200 amp machine, full pedal for most of the welding. A lot of people ask why we didn’t use a spool gun. Why we didn’t MIG weld it. We certainly could have. Part two’s not ready yet. I want to wait until all the shots are finalized and the awning is hung in place where you can see the finished product. read more

How to TIG Weld Aluminum Part 3 – AC frequency settings




TIG Weld Aluminumg

Video Transcript

How to TIG Weld Aluminum: Part 3 – AC Frequency Settings

Hey, Jody here with WeldingTipsandTricks.com. Today is Part Three of a how to tig weld aluminum series. In Part One, I asked for questions and comments. One of the most frequently asked questions was, “What about AC frequency? Can you explain where you would want to use certain frequency settings?” A lot of newer tig inverters have this setting. Today I’m going to take a look at that, and try to answer some of the questions that came in on AC frequency settings, where do you use a low frequency, where do you use a higher frequency setting, and what’s a good all around setting that will work for most everything. Let’s do it. read more

How to TIG Weld Aluminum – Part 2





TIG Weld Aluminum

Video Transcript

How to TIG Weld Aluminum – Part 2

This is part two in a how to TIG weld aluminum series. In part one, I asked for comments, and I said that the comments are going to sort of determine the direction I go with this and the topics that I cover. Well, I got a lot of them, a whole lot. Like, over 350 comments so far. So I’ve got to figure out how to address that, and I’ve got to get a game plan together. read more

Older posts

© 2018 Weldmonger™

Back to Top ↑