Tag: weld aluminum (page 1 of 7)

AC Frequency Settings: TIG Welding Aluminum






TIG Welding Aluminum

Video Transcript:

AC Frequency Settings: TIG Welding Aluminum

I’m TIG welding aluminum today, and I’m comparing AC frequency. I’m gonna compare 50 hertz to 250 hertz. I’ve got some aluminum tubing, some eight-inch aluminum tubing, O-70 wall. It’s a bit less, a little bit less than two millimeters thick. I’m gonna set it up on a positioner and I’m gonna compare penetration, same amperage, 50 hertz, 250 hertz. Let’s do it. read more

Razor Blade Challenge – Welding Razor Blades





Welding Razor Blades

Video Transcript:

Razor Blade Challenge – Welding Razor Blades

So there’s this thing that’s been going around Instagram for quite a while now. It’s called the razor blade challenge (#razorbladechallenge). And basically, normally it’s welding, most often it’s welding box cutter blades – literally welding razor blades. They’re a little bit easier to manage than the single-edge or even double-edge, really thin razor blades. But it’s all good practice. It’s not just a parlor trick. It’s not just showing off. It’s really good practice. read more

Aluminum Tote Tray Project


Tote Tray Project

Below are some products that I don’t carry, but I use them in my videos and can vouch for their quality.

WELDING MACHINES

Lincoln Viking 3350 w/4C

http://amzn.to/2rRFlUn

Lincoln Square Wave TIG 200

http://amzn.to/2rSkekZ

Lincoln Power MIG 210 MP

http://amzn.to/2s2bRnA

AHP Alpha TIG 200X

http://amzn.to/2s1XAr3 read more

Welding Aluminum: MIG Spool Gun vs TIG




Welding Aluminum

Video Transcript

Welding Aluminum: MIG Spool Gun vs TIG

Hey. Jody here, with WeldingTipsandTricks.com. Last week’s video was part one of the aluminum awning build. We put together a lot of the structure in JD’s shop, all TIG welding with a 200 amp machine, full pedal for most of the welding. A lot of people ask why we didn’t use a spool gun. Why we didn’t MIG weld it. We certainly could have. Part two’s not ready yet. I want to wait until all the shots are finalized and the awning is hung in place where you can see the finished product. read more

Welding Aluminum at JD’s shop




Welding Aluminum

Video Transcript

Welding Aluminum at JD’s Shop

Today, we’re doing a little tig welding on aluminum, on a aluminum awning project at JD’s shop, Apex welding and we’re pushing this 200 amp machine pretty hard. Full disclosure here, this is sponsored video, but I did not pay for this machine. I asked them to send it to me because I got a lot of questions about it. Couldn’t answer it. All I could say was I’d never welded with it before. read more

Older posts

© 2018 Weldmonger™

Back to Top ↑