Here Comes the Mig Welder Boom – Part 2

Mig Welder


Click here to subscribe to my Video of the Week!




This is Part 2 of building a boom arm for a mig welder. A millermatic 250 mig welder to be exact.

The aim is to remove the wire feeder components from the welder and install them in a separate wire feeder cabinet that will hang on the end of the boom.

This is a prototype so I will make changes along the way. The hinge is kinda small and the base plate might be too light… But all these things will come to light when it’s done and in use.

There are lots of small shop owners out there who could benefit from a wire feeder on a boom arm.

Maybe you’re one of them. It is a much cheaper way to go than buying a separate wire feeder unit.

I welcome any suggestions so lets hear them…


( As always, feel free to visit us at our sister site, WeldingTipsAndTricks.com. )


Click here to subscribe to my Video of the Week!


3 Comments

  1. What kind of welding table is that? And could you make it yourself?

  2. Thx Jody………very good stuff……..!!!!!

  3. H. Jack Morgan

    April 24, 2013 at 7:20 PM

    Jody,
    Thanks for what you do. They just keep getting better.
    Best regards, Jack

Leave a Reply

Your email address will not be published.

*

© 2024 Weldmongerâ„¢

Back to Top ↑