This is part 2 of the aluminum intake manifold welding project.
A little thick to thin welding…
And a tip for getting good smooth penetration when there are gaps.
Category: Tig (page 19 of 43)
This aluminum intake is for a 280z project car.
the mounting flange plate is 1/2″ thick 6061 aluminum and the tubes are .125″ wall thickness.
A few more tips for scratch start tig welding along with walking the cup, stick welding, and welding with a tiny welder.
Going over the basics of hooking up a scratch start TIG to a DC stick welder.
Taking a quick look at Lincoln's Square Wave TIG 200, so I'm gonna start with some thin steel and aluminum.
© 2024 Weldmonger™
Back to Top ↑