Tag: how to mig weld (page 2 of 10)

Mig Welding with low wire speed


Mig Welding

Using too low a wire speed can have a big effect on penetration. Not a problem on thin stuff or 11 ga outside corner joint but on a tee joint where more heat is needed, too low a wire speed can definitely result in lack of fusion. read more

Mig Welding on Saturday – mig gases and weld symbols

mig gases

I had a rush Mig job on a Saturday and ran out of c25 (75argon/25co2) mig gas.
but I had plenty of straight Co2. So lets talk a bit about mig gases and maybe just a tad about weld symbols. read more

MIG Welding Using Co2 Gas – Lincoln Power MIG 210mp

Lincoln Power MIG 210 MP part 3. Using straight CO2 gas compared to 7525 Argon CO2.

Lincoln PowerMig 210 MP – TIG, MIG, Stick Demo

Lincoln Power MIG 210 MP part 2. Using it for lift arc TIG, a little Stick, and a little MIG

MIG: Open Butt 3G Plate Test

MIG Welding again this week with an open butt plate test in the 3G position.

Older posts Newer posts

© 2024 Weldmongerâ„¢

Back to Top ↑