Tag: mig welding (page 2 of 11)

Quick Tips for Mig welding Uphill

Mig welding Uphill

Quick Summary for mig welding lap joints and tee joints uphill

KYSS…Keep your stickout short. Stickout is the amount of wire sticking out between the contact tip and the arc… If you aim for about 3/8″ (9mm) stickout, you will probably have more stickout than you think. read more

Mig Welding with low wire speed


Mig Welding

Using too low a wire speed can have a big effect on penetration. Not a problem on thin stuff or 11 ga outside corner joint but on a tee joint where more heat is needed, too low a wire speed can definitely result in lack of fusion. read more

Mig Welding on Saturday – mig gases and weld symbols

mig gases

I had a rush Mig job on a Saturday and ran out of c25 (75argon/25co2) mig gas.
but I had plenty of straight Co2. So lets talk a bit about mig gases and maybe just a tad about weld symbols. read more

MIG Welding Using Co2 Gas – Lincoln Power MIG 210mp

Lincoln Power MIG 210 MP part 3. Using straight CO2 gas compared to 7525 Argon CO2.

Lincoln PowerMig 210 MP – TIG, MIG, Stick Demo

Lincoln Power MIG 210 MP part 2. Using it for lift arc TIG, a little Stick, and a little MIG

Older posts Newer posts

© 2024 Weldmongerâ„¢

Back to Top ↑