Tag: mig welding tips (page 2 of 10)

TIG, MIG, and Stick Welding Tips from the 2015 DVD set

Stick Welding Tips

I am guessing that if you are reading this, at least one of the next few statements describes you. read more

Welding Tips for Tig, Mig, and Stick

Welding Tips

Have you ever been to Fabtech?
Its North Americas largest welding and fabrication show.

I am heading out the morning after I am writing this for 3 days of “total immersion” into the world of welding a fabrication…all under one roof. read more

Quick Tips for Mig welding Uphill

Mig welding Uphill

Quick Summary for mig welding lap joints and tee joints uphill

KYSS…Keep your stickout short. Stickout is the amount of wire sticking out between the contact tip and the arc… If you aim for about 3/8″ (9mm) stickout, you will probably have more stickout than you think. read more

Mig Welding with low wire speed


Mig Welding

Using too low a wire speed can have a big effect on penetration. Not a problem on thin stuff or 11 ga outside corner joint but on a tee joint where more heat is needed, too low a wire speed can definitely result in lack of fusion. read more

MIG Welding Using Co2 Gas – Lincoln Power MIG 210mp

Lincoln Power MIG 210 MP part 3. Using straight CO2 gas compared to 7525 Argon CO2.

Older posts Newer posts

© 2024 Weldmongerâ„¢

Back to Top ↑