Welding Cart Project: Part 5… Done and Done.

2 Comments

1. Mike Challgren

   July 19, 2014 at 4:06 AM

   Nicely done. I can use part of this design to hold my old standby Oxy-Acetylene set up.

   Reply
2. John

   July 16, 2014 at 12:34 PM

   I like the concept of using a v-support for the cylinders,rather than bending U-shapes to match the cylinder diameter. The V allows the use of multiple cylinder sizes with no “slop” in the support area. Could you tell us what the maximum size cylinder the cart is capable of holding? Did you have a certain size in mind when you designed the cart?

   Reply