I am guessing that if you are reading this, at least one of the next few statements describes you.
Category: Aluminum (page 7 of 15)
This is the final video in the series on tig welding an aluminum intake manifold.
1. I had to get a simple fixture to locate the fuel injector bungs so that they would fit to the fuel rail.
2. its handy to have a few drill press vises to hold odd shaped parts.
3. if you have a gap in aluminum sheet, sometimes it helps to do a cold pass and follow it up with a penetration pass.
This is part 2 of the aluminum intake manifold welding project.
A little thick to thin welding…
And a tip for getting good smooth penetration when there are gaps.
This aluminum intake is for a 280z project car.
the mounting flange plate is 1/2″ thick 6061 aluminum and the tubes are .125″ wall thickness.
Taking a quick look at Lincoln's Square Wave TIG 200, so I'm gonna start with some thin steel and aluminum.
© 2024 Weldmonger™
Back to Top ↑